laboratory sink manufacture

Laboratorysink(lab flume)Material: Polypropylene;
1.Bottom has filled the sink with drain holes, with a transparent PVC drain hose;
2.two sizes: W420 * H550mm and W550 * H700mm;
Features:
1 whole body is plastic injection molding, high strength, light weight;
Two main parts of PP material, no secondary pollution;
3 Install drip rod tilt 4000, utensils properly seated;
4 movable drip stick to the card marked with the body binding, may be easily folded front loaded saving convenience;
5 The body has 55 mounting holes, the inner seal with a special design to prevent leakage;
6 to decide the number of installed drip stick, open set of holes covered by the hole plugs, keeping nice;
7 gutters with a tilt angle of catchment easy, rapid drainage;
8 with single-sided and double-sided wall-mounted Desktop, choose from;
9 drip rod maximum load up to seven kilograms important